Operating Modes
The measuring tool has several operating modes, which you can switch between at any time. The horizontal and vertical modes can be switched on and off independently of each other. After switching on, the measuring tool is in horizontal mode.
All operating modes can be selected with both automatic levelling or the pendulum lock.
The measuring tool has multiple vertical modes:
- Vertical laser line forwards
- Vertical laser line forwards and to the right-hand side
- Vertical laser line forwards and backwards
- Vertical laser lines to all four sides
A plumb point is additionally projected downwards in vertical mode.
To switch the vertical mode on/off or to change the vertical mode, press the vertical mode button (18) repeatedly until the required operating mode is reached.
Receiver mode must be activated when working with the laser receiver (22), regardless of which operating mode is selected.
In receiver mode, the laser lines flash at a very high frequency, enabling them to be detected by the laser receiver (22).
To switch on receiver mode, press the receiver mode button (17). The receiver mode indicator (15) lights up red.
When receiver mode is switched on, the laser lines are less visible to the human eye. Therefore, switch receiver mode off by pressing the receiver mode button (17) again to work without a laser receiver. The receiver mode indicator (15) will go out.